SKU: N/AThis site contains affiliate links for which we may be compensated
Consumer Electronics / Vehicle Electronics & GPS / Car Audio / Car Amplifiers
BRAND NEW IN BOX JL AUDIO JD250/1CLASS D AMPLIFIER w/ NexD Switching technology MONOBLOCK SUBWOOFER AMPLIFIER250 WATTS RMS x1 @ 2 OHMS160 WATTS RMS x1 @ 4 OHMSDIMENSIONS: 7-7/8"W x 2-1/8"H x 7-11/16"DJD Amplifiers redefine a high-value package in terms of performance and efficiency. JL Audio’s NexD ™ switching technology and clipping indicators (for ease in setting Input Sensitivity), add tremendous bang for your buck. Their dual-range, differential-balanced inputs minimize noise, while maximizing compatibility with a wide range of signal levels. Monoblock models also include variable bass boost and Remote Level Control capability when used with an optional RBC-1 Remote Bass Control.They fit nearly anywhere! JD250/1: 9-9/16"W x 2-1/8"H x 7-1/2"D. High-mass heat sink improves thermal capacity leading to reduced incidence of shut-down events.NexD™ Switching Amplifier Technology: Our high-speed switching technology delivers outstanding fidelity with very low noise and distortion. Exceptional efficiency results in reduced current draw and heat, permitting reliable high power output within a very small chassis. Specifically optimized for subwoofer applications (7 Hz - 500 Hz bandwidth).Complete Signal Processing Package: 12dB/octave low-pass filter, non-defeatable, with fully variable filter frequency selection from 50-500 Hz. Adjustable 0 to +12 dB Bass Boost EQ @ 45 Hz. Remote level control with optional controller (RBC-1). Preamp outputs (buffered, pass-through type)Dual-Range, Differential-Balanced Inputs and Automatic Turn-On Capabilities Benefits: NO NOISE! Outstanding noise rejection prevents alternator whine and other noises. Accepts line-level or speaker level signals (up to 8V RMS), including those from factory systems, without a line-output converter (LOC): just splice wires to a pair of RCA ends or RCA cables. Automatic turn-on option via Signal-Sensing or DC-Offset sensingIntegrated LED Clipping Indicator for Easy Setup: Simplifies input-sensitivity setting by providing accurate visual feedback of output clipping level.1) Disconnect one speaker output wire, 2) Play full-scale (0 dBfs) sine-wave through audio system, with head unit at 3/4 volume and tone controls set flat, 3) Adjust input sensitivity until light turns on, then back off slightly. Separate, top-mounted LEDs report overall status and conditionProduct Highlights:Mono subwoofer amplifier250 watts RMS x 1 at 2 ohms150 watts RMS x 1 at 4 ohms1 ohm NOT RECOMENDEDClass D amp design with NexD™ switching technologyFrequency response: 7-500 HzVariable low-pass filter (50-500 Hz, 12 dB/octave)Variable bass boost (0-12 dB at 45 Hz)Optional RBC-1 Wired remote level controlPreamp inputs and outputsdifferential-balanced inputs prevent noiseSpeaker-level input via Rca inputssignal-sensing turn-on with speaker-level inputsWiring, fuse, and hardware not included with amplifier8-gauge power and ground leads and a 30-amp fuse recommended
Returns Accepted for this item if it's within 30 Days